Renaming it 7 mm-06 Remington seemed like a good idea until it dawned on someone at the company’s Ilion, N.Y., factory that headspace dimension for the old wildcat was longer than for the. 280 Rem., which had also been a slow seller. The decision was then made to replace those barrels, but before the job was completed a few of those rifles managed to escape from the factory. When shortly thereafter it was changed to just plain “6 mm Remington,” someone took hammer and steel “X” stamp in hand and attempted to obliterate the word “Mag” on the barrels of the few rifles built. Introduced in the earlier Model 722, it had never set the woods afire in sales so when the Model 700 went into production, its name was momentarily changed to “6 mm Remington Magnum” and the barrels of a few rifles were roll-marked accordingly. Some cartridges have had more than one name-the. Remington has adopted more wildcat cartridges than any other company, including. Some of the in-house designs include the. Quite a few of the cartridges were either developed by Remington or dreamed up by wildcatters and eventually adopted by Remington. Unless my count is off, there have been 51 chamberings ranging from as tiny as the. Model 700 sales skyrocketed immediately, and during the first three years more rifles chambered for the new 7 mm Rem. Those in magnum calibers were stainless steel and since this was long before anything other than a blued finish was widely accepted among hunters, Remington went to great expense in plating each barrel, first with copper and then with iron so it could be blued. By 1964 barrels in those calibers increased 2 inches in length. A big mystery at the time was Remington’s decision to put stubby 20-inch barrels on all rifles in. soon after it came out in 1962 and not once during 50 years of hunting has it lost zero.īarrel lengths varied among the chamberings. While it might not be considered pretty by today’s standards, it was tougher than nails and much better than an oil finish at preventing entry of moisture into the stock. The new stock was also clad in what Remington advertisements described as the “RKW Bowling Pin Finish” and since DuPont had actually developed it as a near indestructible finish for use on bowling pins, it lived up to its name. From a distance it looked like any other checkering applied in an attractive fleur-de-lis pattern, but closer examination revealed each tiny diamond pointing inward-rather than outward as is the case for cut checkering. Hand-cutting checkering into a walnut stock was quite time-consuming so to reduce production cost, special tools were used to press the checkering into the surfaces of the Model 700’s grip and fore-end. At the time the Winchester Model 70 in standard calibers sold for $139. Prices for magnum versions of the BDL were $154.95 for the. Introductory prices for standard calibers were $114.95 for the ADL and $139.95 for the BDL. It also came with a nice leather sling in quick-detachable swivels. The ADL had a blind magazine while the more expensive BDL had a hinged floorplate, black grip cap and forearm tip and more checkering coverage. The new rifle was offered in short- and long-action versions and in two grades. Its first advertisement appeared in the June 1962 issue of American Rifleman. Basically a modified version of the earlier Model 721, the Remington Model 700 was designed by a team of engineers headed by Mike Walker.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |